What is best method to weld cast iron?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by DG on Monday, February 10, 2003 at 8:11PM :

I have some spring blocks that I got that have a torch hole from when someone cut them out of the donor truck. What welding process is best too use to fill the 3/4"x1/4" hole and a couple deep gouges.
Thanks,
David

Follow Ups:

What is this part you have???? - Eric B. 11:28PM 02/10/2003

Probably not cast iron - RDavis 10:12PM 02/10/2003

Block goes between axle perch an springpack - DG 10:21PM 02/10/2003
- Re: Block goes between axle perch an springpack - Dan Shockley 10:59PM 02/10/2003

Re: What is best method to weld cast iron? - Joe Lorenzino 9:15PM 02/10/2003

good ole lo-tech, Braze it ! or bondo? - casebro 9:08PM 02/10/2003

Re: What is best method to weld cast iron? - Rick E 8:53PM 02/10/2003

Re: What is best method to weld cast iron? - Gordon Maney 8:24PM 02/10/2003

If it's not structural use Ni-rod ntxt - Marty 8:40PM 02/10/2003
Re: What is best method to weld cast iron? - Evan 8:36PM 02/10/2003
- Thanks for your input and ideas! - DG 10:32PM 02/10/2003

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com