Posted by Marty on Wednesday, January 01, 2003 at 5:31PM :
In Reply to: Brake adjustment on 49 PW posted by Marc C on Wednesday, January 01, 2003 at 4:40PM :
Sorry Marc, I guess it was 2 forums ago.
Here's Vaughn's Brake Adjusting advice from Best of the Forum:
Posted by Vaughn on Wednesday, December 18, 2002 at 8:13PM :
In Reply to: Brake adjustment question posted by Jeff in N. Texas on Wednesday, December 18, 2002 at 7:22PM :
Adjustment
To adjust the brake shoe the following steps should be taken with wheel off the ground:
On the brake plate there are two ¾ inch nuts upper area, one on each side. Turn the front (front side of axle) brake shoe cam adjusting nut out (counter clockwise when facing wheel (driver side), or clockwise when facing brake plate) until wheel is locked, then back off until the wheel will spin;
Turn the cam for the rear shoe out (clockwise when facing wheel or counter clockwise when facing brake plate) until wheel is locked, then back off until wheel will spin;
Reverse for passenger side;
When bleeding start with rear passenger side wheel, then rear driver side, then front passenger then front driver side as final. Repeat until air is out, BUT MAKE SURE YOUR ARE CHECKING MASTER CYLINDER FLUID LEVEL FREQUENTLY DURING PROCESS to avoid pumping air into brake system; Adjust brakes, then bleed!