Posted by Willy-N on Tuesday, December 24, 2002 at 9:08PM :
In Reply to: Re: Transfer Case locks up in High??? Help Please! posted by Vaughn on Tuesday, December 24, 2002 at 6:48PM :
Well I did not remove the shift rail. I just put the seals in. I think this was a problem befor I touched it because I did notice if you push the shift in all the way it would lock but if you pulled it out a little it would not. I was not seeing if it was changeing ratios just shifting. After I replaced the seals is when I noticed it was not going into high gear. Then I pulled the plate to go further inside for a look at the gears. I have not disasembled it any further then pulling out the gear that will slide right out. I replaced 30 rollers 15 per gear today makes no difference. Tomorrow I will pull the little gear and see why it won't go all the way over after I check for rust in the detent balls on the shaft and for a bent rail or shifer. At least now I have something to go on. Not many moving parts in there to go wrong. I just thought I would ask befor I went further on it. Thanks, Mark H.
Follow Ups: