Re: Repeat crank question

Posted by Vaughn on Thursday, December 19, 2002 at 9:53PM :

In Reply to: Repeat crank question posted by Jerry Henry on Thursday, December 19, 2002 at 9:27PM :

Might be easier to a 9/16ths steel rod, put a 5/16ths bolt in one end, extended 3/8ths each side, and a couple of bends to make a crank.

Have you tried to turn it over using the stater?

Re: Repeat crank question - Jerry Henry 2:04AM 12/20/2002

Re: Jerry You could also.............. - George (Alberta) 8:26PM 12/20/2002
- Re: Jerry You could also.............. - Jerry Henry 9:16PM 12/20/2002

This board is powered by the Mr. Fong Device from Cyberarmy.com