Posted by Willy-N on Monday, December 16, 2002 at 11:20PM :
I completely dissasembled and cleaned the Transmission to night. All the gears were nice with no apparen wear except for rust!! The Top Cluster which was out of the oil had rust on it. I cleaned them but there is pitting on the gear teeth and the shaft where the gear slids on is pitted too. The bearings were good on the shaft under the gears but the 2 on the ends are bad. NOW do I get another transmission or can I get a set of new matching upper and lower gears and upper shaft assembley for it? Have no idea of cost? Or where to get new ones. I can get a used trans but then I will have to tear it all apart also and could run into the same problems. Any ideas? Mark H.
Follow Ups: