Posted by Willy-N on Tuesday, December 10, 2002 at 0:30AM :
In Reply to: See parts suppliers, Mars & B. Stahl site! posted by not scared of no book! on Monday, December 09, 2002 at 11:04PM :
I just went over to my freinds house and we are going to ink the gears to check mesh. Also will go over the adjustment with me. I think I allready have it right but just wanted to make sure. I don't use books on the tractors anymore I can allmost do them blind folded after 13 of them in one year! I am going to get a few weeks off for Christmas and don't want to waste the time. In a month there will be 12 plus inches of snow on the ground and 15 degs in my shop. Then it is called cold steel on the bare fingers. Once I get going I don't stop I did that tractor in 2 weeks. This will take longer because I can't use my sand blaster or presure washer to cold out. Now I have to do it all by wire brush and arm strong cleaner (by hand). Going to put the engine and trans together on the outside and drop it in. I was tring to get the underside done befor I filled up the holes with parts lots of room right now. Mark H.
Follow Ups: