Posted by Vaughn on Monday, November 25, 2002 at 10:19PM :
In Reply to: brake line diagram needed posted by Galen on Monday, November 25, 2002 at 8:15PM :
Is kit preformed or just cut to length?
1. Match the differentials. Each diff has a "Tee" fitting. Try matching lengths from Tee to brake plates allowing extra length for bending. Tubes lay flat along axle housing
2. Match from the MC to the frame "Tee" Probably is shortest tube.
3. From master cylinder to front cross member front hose connection is probably one length. Goes from MC along frame to crossmember, then 90 degrees right down along crossmember
Remaining lengths would be from frame Tee rear crossmember hose connection.
Tip - Use wire to form tube bends and length, then straigthen wire to match tube lengths. Good Luck!
Your replacing the hoses to right?