Posted by Steve Elliot on Saturday, August 10, 2002 at 7:05PM :
In Reply to: Re: Winch Drive Shaft posted by T-roy on Saturday, August 10, 2002 at 4:05PM :
I used Napa 853. However I had to do some work to get them to fit. The caps stuck out too far to get the end caps screwed on. I had to grind both ends of each cap and grind the end of each stub to shorten the stubs and caps enough to get the end plates on. Fortunately I work in a machine shop so no problem. I hope the other part numbers work for you. I wrote them down in case I need them again sometime.
Steve