Posted by Timmy on Sunday, July 28, 2002 at 11:05PM :
In Reply to: Problem identified--is there a solution? posted by Gil Huguley on Sunday, July 28, 2002 at 9:20PM :
Performance gear at www.4x4gearmasters is up on imput shaft machining, there are very few people doing this, will look for the other 2 shops i have had emails on. Where are you, ever consider clark, spicer 5 speed od? They are cheaper and cast iron case, true 500000 mile trannys. Advance adapters might be able to help, in cal, also I have drilled out an automatic crankshaft to standard while in a car(69 roadrunner) is not brain surgey like others have insisted machine shop necessary, hell, get some good starting bits and start drilling out to larger, u can get mag base drill to stick on flywheel from rental house and do it yourself it u want. Same thing machine shop would use it u took it in. Minn and ohio are 2 locations that have spliners. Good luck on swap.