Re: Yoke Nut Tool

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Gary on Tuesday, July 09, 2002 at 2:35PM :

In Reply to: go to med duty tranny rebuilder lots 540 in jy posted by Brushbuster on Tuesday, July 09, 2002 at 1:47PM :

Guess I didn't make myself clear. I need the tool to remove the Yoke retaining nut... Tool number DD-406. It would have 6 radial prongs with a hole in the middle (1 inch approx. threaded shaft) and perhaps a 1/2 or 3/4 drive. This nut is like a round castle nut, and not hexagonal.

I'm planning on putting in the 12" clutch. I don't have a W500 bell,but I bet it's the same as most Power Giants with the 318 Poly. I'm bolting the 540 to my 318P bell. I'm in CO.

Gar

Follow Ups:

Re: Yoke Nut Tool - David 7:07PM 07/09/2002

Re: Yoke Nut Tool - Brushbuster 4:34PM 07/09/2002

Re: Yoke Nut Tool - Gary 6:51PM 07/09/2002
f600 ford had that trans for p/n tool,gmc also 2ton - Brushbuster 5:03PM 07/09/2002

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com