Posted by Cheyenne Dave on Friday, June 28, 2002 at 9:16AM :
In Reply to: Warn Hub Is Squirtin' Grease! posted by Chris in Penn Valley on Friday, June 28, 2002 at 0:29AM :
Start off with a clean shop rag and a clean and empty bench area. Lay out all the components in a linear fashion and carefully clean each one. If you have the M-14 hubs, there are a pile of needle bearings inside, so be careful not to let any get away! I can't remember now if that is true with the M-13's or not. The only place for grease to escape is through the paper gaskets (2) or the rubber gasket that seals the Bronze locking disk. You can substitute Blue RTV silicone for the paper gaskets, but if the rubber seal is damaged, you can probably get replacements through Warn.
Follow Ups: