Posted by Utah Craig on Saturday, June 22, 2002 at 3:20PM :
My over enthusiasm while disassembling my E7-S1 carb from my '52 B3-PW has gotten me into trouble. I pulled the governor assembly off of the throttle body before reading the note in my shop manual stating not to disassemble the two pieces. Here is the problem: there is no exploded view showing the lower throttle shaft through the body to governor assembly. The ball bearings are straight forward enough, but I cannot tell where in the sequence the two rubber groumets go. Is it between the bearings & housing (next to the throat), or on the outside, or just where? It's been too long since disassembly for my memory. I am stopped dead without your guys' help.
Thanks in advance,
Craig (the hard learner) Howard
Follow Ups: