Posted by RDavis on Tuesday, May 07, 2002 at 10:03PM :
In Reply to: Re: Stainless steel- heating/cooling problems ? posted by Hemi Power on Tuesday, May 07, 2002 at 6:14PM :
I cannot devulge my intent ( secret project)
but I need them to be weld bends,tees,and 90degree reducers. No special SS will be needed if all
SS will endure High heat (1200 degrees +or-).
1/8th - 3/16th wall thickness should be fine
as long as it can be welded.