Posted by Vaughn [172.69.140.184] on Wednesday, April 10, 2024 at 14:41:55 :
If your installing with the trans bolted to the bellhousing and install before you bolt the bellhousing to the engine, piece of cake. Not so easy when the bellhousing is already installed on the engine, but I got it done with a little dish soap. There is a rubber O-ring inside the TB unit that is on the trans end, if you don't lube it with something, impossible to slide it on the retainer, especially when you have little room to work and only able to use your fingers. Otherwise it's a nice setup for a TB unit. Next step is to place the clutch pedal vertical to ensure the MC rod is level, the rod stroke is limited to 1-3/8ths travel, and bleed the system
Follow Ups:
