Chevy Conversion Status

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Vaughn [172.69.140.163] on Sunday, November 19, 2023 at 14:46:22 :

- The rear mounts and torque moderator are done,

- Bolts secured by wire,

- Carb will set good,

- Engine is raked and should not experience propeller shaft vibration based on service bulletin posted below. It is between 3/8 and 1/2 inch lower at rear,

- Based on frame at rear of engine, and the two engine mount bolts in front, engine is straight in frame, sets 3/4 inch to the right off-center.

It was a little bit of work, but was fun doing. Now to move to the front and start the front engine mounts.

link

Follow Ups:

Re: Chevy Conversion Status - Jerry in Idaho 15:42:24 11/19/2023

Re: Chevy Conversion Status - Vaughn 16:59:15 11/19/2023
- Re: Chevy Conversion Status - Bob 18:52:45 11/19/2023
  - Re: Chevy Conversion Status - Vaughn 20:23:48 11/19/2023

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

(1) Type your Message (2) Load New Code (3) Type new code into box. (4) Click "Post Message" button