Posted by Johnd [172.69.62.175] on Monday, February 11, 2019 at 12:13:57 :
In Reply to: Re: axle bushings and seals posted by Don in MD [162.158.142.13] on Monday, February 11, 2019 at 09:14:41 :
Don, use a die grinder to cut a slot in the bushing. You dont need to cut all the way thru, just enough to make the bushing give when pulling with your slide hammer. If you dont have n actual fie grinder, use a die grinder bit in a drill.
I like the bit with the ball shape on the end. You can buy them at a decent hardware store, but get one bigger than a dremel tool size. One with a 1/4” shank would be best.