1993 cummins frame replacement

Posted by 1993cummins [108.162.219.175] on Sunday, September 23, 2018 at 17:22:52 :

Hello, I have a 1993 w250 cummins the has significant rust where the gas tank sits next to the frame. Im looking to replace that section of frame. Its from where the back of the cab to the start of the axle hump. Does anyone have a frame piece that would fit? Also does anyone have any other solutions I could do rather then replaceing it with a factory piece? I was thinking about cutting a piece of angle iron to fit as it is only the bottom half of the frame that needs replacing but not sure if that's the best thing. Any tips and tricks are a help. thanks

Follow Ups:

• Re: 1993 cummins frame replacement - Vaughn 18:33:48 09/24/2018
  • should not need moly for this - Bruce in seriously wet BC 01:05:33 09/25/2018
    • Re: should not need moly for this - Vaughn 08:39:57 09/25/2018
  • Re: 1993 cummins frame replacement - Jim in Ct. 20:42:35 09/24/2018
• How soon do you need it? - Don in Missouri 15:21:38 09/24/2018
  • Re: How soon do you need it? - Jim in Ct. 20:40:38 09/24/2018
• do not use angle iron - Bruce in seriously wet BC 00:51:55 09/24/2018
  • Re: do not use angle iron - Jim in Ct. 07:31:28 09/24/2018
    • rectangular tubing - Bruce in seriously wet BC 11:03:10 09/24/2018
      • You can do that? - Jim Lee 14:50:18 09/24/2018
        • grey area - Bruce in seriously wet BC 15:11:23 09/24/2018
          • Re: grey area - David Lundstrom 21:05:04 09/24/2018

Post a Followup