Posted by Willy-N [108.162.246.140] on Monday, September 03, 2018 at 15:44:10 :
Well I got her done except for the valve body and that is the easiest part to do. Waiting on a little rod I need. The shafts spin by hand. Found a bushing that had shifted and was holding the Thrust Bushing out a little. That was a easy fix then I took the whole inside apart again just to be sure nothing else was damaged and it was OK. To get it unstuck I just tapped it a little in a turning directions and it moved!! It was stuck on a notch on the side of the case. Just took sleeping on it and afresh start. I feel good now it is all correct enough to put it in the truck once the vale body is installed. I could have gave up a couple times but glad I did not!
Follow Ups: