Posted by Milo in Pa [162.158.79.8] on Thursday, July 12, 2018 at 18:08:00 :
In Reply to: WC radiator question posted by Bruce in too windy to weld BC [108.162.245.127] on Wednesday, July 11, 2018 at 21:58:35 :
On the front nose panel on mine someone did a nice job and cut a piece out on each side so you can get at the 4 bolts that hold it down. When I put the welting on I cut it at the panel seam and drilled a hole for a extra rivet. Now I can lift it right off after taking the grille bolts out. I put vice grips (you can see in the picture) to hold the hood so it dont slide forward. I did this while assembling my truck and having to remove the radiator once it was a lot easier. The shroud was a tight fit sliding it down I think if I have to take it apart again I will cut some off the sides of the shroud