Posted by Bruce in too windy to weld BC [108.162.245.127] on Thursday, July 12, 2018 at 00:45:35 :
In Reply to: Re: WC radiator question posted by mannyc [162.158.63.241] on Wednesday, July 11, 2018 at 22:46:30 :
I will do my best and post pictures on the Carryall thread.
On the side pieces there are some swagged nuts - those I removed.
On the top of the shroud where the bolts went through I welded in some flange nuts.
You have to cut a relief to clear the bolt for the front - this is to provide clearance to get the bolt in and out and room for the wrench. I will get the dimensions on the relief cut tomorrow and post pictures on the carryall thread as well.
To get to the rear bolts you need to use an extension, I thought it would be hard but it turned out to be quite easy, because you can see what you are aiming at.
If you set the top in place and imagine switching the bolts from the top to the bottom it will start to make sense. I am very glad I went this route and did this mod.
Follow Ups: