Posted by Keith in Washington [162.158.106.45] on Thursday, June 07, 2018 at 10:20:17 :
In Reply to: Taking out the bench seat to recover posted by Jim in Arkansas [172.68.34.103] on Thursday, June 07, 2018 at 03:33:30 :
Pull the seat bottom forward a couple of notches. Then reach between the seat base and seat back around 8” from each side pushing down on the metal seat base loop and lifting on the seat back hook to separate them. When both sides are disconnected carefully side the seat base out.
To remove the back remove the rear window trim then the small cardboard piece below the window. You will see 4 screws at the to of the seat back that hold it in place. Be careful the rear window may fall out. Remove the seat back out of the cab.
Installation is just the reverse. Be careful when putting the seat base into the cab. The metal hoops and the back of the seat can cut the seat back. Don’t ask me how I know this.
Follow Ups: