Re: Differential Gasket Thickness


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Matt Wilson [108.162.221.179] on Saturday, January 20, 2018 at 11:33:31 :

In Reply to: Re: Differential Gasket Thickness posted by Dougdodgeman [172.68.58.104] on Friday, January 19, 2018 at 10:05:32 :

Hi Doug, no, I already had the flanged seal installed on the hub before I installed the axle shaft. As it turns out, I think the interference was due to tolerances of the holes in the axle shaft flange vs. Tolerances in the studs. In certain positions, I could put thw shaft all the way in by hand, with little effort, but if I pulled the shaft and rotated it and then reinstalled it, in some cases it would not go all the way in without light tapping by a dead blow hammer. I think certain holes were better aligned with certain studs, and not so well-aligned with others.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


Enter the characters in the image to the left or Load New Code