Posted by Andrew in MI [172.68.206.85] on Saturday, January 13, 2018 at 21:41:37 :
In Reply to: WM300 vacuum line to brake booster posted by Andrew in MI [172.68.206.85] on Saturday, January 13, 2018 at 08:48:13 :
Here are the manifolds I have on my truck. The intake manifold sits higher, almost flush to the top of cylinder head instead of lower, to accommodate a velocity governor. I don't have a velocity governor either. That's a BBS carb.
There is no heat riser either in the exhaust manifold, but there is that brass plug in the bottom of the intake. There is another port on the left hand side of intake just below the carb I could hook PCV fitting.
The block is an industrial 251 engine instead of original truck engine, but has PCV ventilation though. There is a rubber tube going from the base of air filter on carb to oil fill tube on other side.
No other places to hook up anything else. The wipers I think I could hook to an unused port on carb.
Andy
Follow Ups: