Re: problem with division bar fit to verticle channel

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by scott56 [172.68.141.169] on Tuesday, August 08, 2017 at 15:24:18 :

In Reply to: problem with division bar fit to verticle channel posted by scott56 [172.68.141.169] on Tuesday, August 08, 2017 at 15:21:50 :

also you can see in the picture the setting tale sticking out past the edge of the channel the door glass fits into. I urethaned in the bottom of the glass but used the tape on the verticl edge. At lease now I can remove the division bar with just two screws.

driveshaft

Follow Ups:

Re: problem with division bar fit to verticle channel - scott56 23:07:11 08/08/2017

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

Enter the characters in the image to the left or Load New Code