Posted by Kaegi [108.162.245.235] on Monday, July 17, 2017 at 17:14:27 :
In Reply to: Re: NP201 Help Canada posted by Mannyc [108.162.219.67] on Monday, July 17, 2017 at 16:45:05 :
its the 201 that has the knocker gear.. the M37 has the 200 (better design) without the knocker set up. but the 200s will clunk when the input and output teeth on the upper shaft assembly get worn out.
on your single speed you can run some rubber between mounting brackets and frame. the factory ran some stuff that was maybe 1/4 inch thick but not much left of it after decades. you could also run longer bolts and put a donut/washer set up on the top side of xmember and some rubber sheet between bracket and xmember and improve it a bit.