Note, 'set screw' should be a zerk.

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Chris Case [173.245.48.192] on Sunday, June 04, 2017 at 16:34:51 :

In Reply to: A Few MU2 Questions posted by Randy On Long Island [108.162.219.235] on Saturday, June 03, 2017 at 16:28:10 :

There is a zerk fitting 90 degrees off from the shear pin. Some have gotten replaced with a set screw. The point of the zerk is to grease the joint between yoke and shaft, so it doesn't rust together and prevent the shearing of the pin.

It's the one weird zerk that is 3/8" fine thread, not pipe thread, so a set screw or bolt goes right in. Ditch the screw, use the zerk.


Follow Ups:


Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


Enter the characters in the image to the left or Load New Code