Posted by Chris Case [173.245.48.226] on Sunday, November 13, 2016 at 22:09:26 :
In Reply to: Re: Would it be more feasible posted by Jeremy Horvath [108.162.221.186] on Sunday, November 13, 2016 at 21:04:45 :
Centrifugal tension gets changed differently on different brands.
Most bed the spring clip part, others use an eccentric pin that you twist to change spring load. Either way, you would need to get inside the dist to swap parts. The big block uses a longer shaft.
Meantime, you might try bumping the initial timing to +10 degrees. If it rattles/pings/detonates, bump it back.
Follow Ups: