Posted by clueless [108.162.212.64] on Thursday, October 27, 2016 at 17:21:12 :
In Reply to: Re: ears posted by Don in Missouri [172.68.58.155] on Thursday, October 27, 2016 at 16:24:24 :
strange--i can t really tell as i am looking at it all in the truck--but looks to me like the bottom of the ears are at least 2 inches below where the crank center would be close to what dan s looks like
and they are just sitting on a pc of plus or minus 1/4 in rubber with springs on the bolts
no i haven t ruled that out and was the plan down the road if i could find ptos for it--jsut find the sae adaptor very interesting as it looks like it just might all bolt up to what i already have
by the same token it looks like some of the mount holes on the 540 match the crash
holes but not sure -- and not sure if there is surface on the bell to drill for the 540 mount holes yet
also looking at my crank there seems to be two areas milled in the end for pilot bushing--one further in for a smaller bushing and one further out for a larger one--the smaller bushing is in there--my 540 would take a larger bushing--then we have shaft lengths