Re: ADVANCE or RETARD.. WHICH WAY TO TURN!!!

Posted by Vaughn [199.27.128.179] on Tuesday, October 18, 2016 at 22:20:49 :

In Reply to: ADVANCE or RETARD.. WHICH WAY TO TURN!!! posted by DDD [172.68.34.159] on Tuesday, October 18, 2016 at 13:38:59 :

- Point gap is .020 for 6V through 24V
- Spark plug gap is .035
- Timing 6-8 degrees BTDC
- It sounds as though you have not installed a ballast resistor that is required for 12V, that's why you get the occasional miss at higher rpms, without it, your points are rapidly burning.
- The carb/choke issue could be from incorrect float level, or air idle screw adjustment.

Follow Ups:

• my coil has internal ballast - Ddd 17:18:00 10/19/2016
  • Re: my coil has internal ballast - Vaughn 23:15:57 10/19/2016
• my coil has internal ballast - Ddd 08:20:42 10/19/2016
  • Re: my coil has internal ballast - Kaegi 11:25:33 10/19/2016
    • A lot... 4-5 full turns - Ddd 17:19:41 10/19/2016
      • I was wrong....5-6 half turns - Ddd 08:17:42 10/20/2016
        • Re: I was wrong....5-6 half turns - Kaegi 19:54:49 10/20/2016

Post a Followup