make your own pitman arm

Posted by ed [108.162.236.193] on Friday, May 20, 2016 at 15:15:52 :

the stock pitman arm i pulled the ball is pretty will worn--might clean up and work?!

i was(am?) gonna use it on the bronco ps box but was gonna have to mod the draglink(cut in half and thread for a sht tie rod) so i can put the holes in line with the balls)

but i could just make or buy one of these and weld in the spline off my not so good stock pitman arm-----by the ball from vpw and ream accordingly it so it lines up with the holed in the drag

Follow Ups:

• Re: make your own pitman arm - Kaegi 17:01:05 05/20/2016
  • Re: make your own pitman arm - ed 10:43:57 05/21/2016
    • Re: make your own pitman arm - Kaegi 11:18:58 05/21/2016
      • oops - ed 19:24:52 05/21/2016
        • Re: oops - Kaegi 20:50:46 05/21/2016
          • Re: oops - ed 10:16:44 05/23/2016
      • brainstorm - ed 13:11:28 05/21/2016
      • Re: make your own pitman arm - ed 12:49:18 05/21/2016

Post a Followup