Posted by Vaughn on Friday, October 05, 2001 at 11:47PM :
In Reply to: Dana 60 front axle posted by Richard Bowman on Friday, October 05, 2001 at 9:04PM :
On the pinion side of the housing are reinforcement webs. The size number is usually cast on one of them.
You will want to make sure the track width is the same as yours, unless you don't mind wider or norrower tracking.
A key point to consider is where the right spring mounts (ring & pinion side), and how much of a difference from yours from the center of the spring to the edge of the tire rim surface of the hub. Do some measurements to see how well it will match up to your suspension.
This board is powered by the Mr. Fong Device from Cyberarmy.com |