Posted by Willy-N [108.162.216.23] on Thursday, December 31, 2015 at 21:24:29 :
Going to bleed them first just in case it is air causing it in the lines? Changed the switch to a real old one I had and they still did not come on. Jumper the switch and they worked so it is not the wiring. They used to work till I put the booster on and a new master cylinder. Could be another bad switch it was a old one I had? I had bled the master cylinder of air but not the 2 ft long new lines I used on each port. Might just be the air not allowing enough pressure to work the switch?? I will pick up a new switch in town tomorrow just in case. Fuel just to go get one cost more than the switch does!
Follow Ups: