Posted by Kevin in Ohio [108.162.237.192] on Monday, December 28, 2015 at 20:06:31 :
In Reply to: Power Steering column mod questions posted by Mike O in CO [108.162.216.20] on Monday, December 28, 2015 at 15:54:06 :
I made a 1/8 inch steal plate that uses original bolting locations in the floor. Kind of a step floor if you will.
Then I bent a 2 half loop brackets up the diameter of the column. Then drilled holes in the tabs. Ground some angles on one side till the column fit nice and tacked it in place. Then took it out and final welded it. Put it back in and that is what you see in the pic here.
Put a round rubber seal around the column and slip it in. I used a thin rubber piece between the column and mount and attached to the dash, then tighten it all down,
Follow Ups: