Posted by Bob In Illinois [73.8.55.5] on Wednesday, December 16, 2015 at 20:12:06 :
In Reply to: Re: Braden LU-2 Winch Rebuild posted by dave horvath [73.154.113.3] on Wednesday, December 16, 2015 at 18:34:10 :
Make sure the shear pin is completely removed and not smeared. Also that there are no set screws installed. It may be a bit awkward to but try knocking the u-joint out of the yolk and then use a two jaw puller hooked into the holes where the u-joint goes.