Pulled the Oil Pump now out of Time!

Posted by Willy-N [72.168.160.175] on Sunday, November 22, 2015 at 17:24:09 :

Put the High Flow one in and messed up sticking it back in. I think I got it right now? Since I drained the block of water to hook up the heater and valve for it plus fix a dripping gasket leak on the thermostat I had to wait to start it up. Took care of the water and oil pressure gauge sending units at the same time. I hate re/timing these engine by myself to get top dead center hanging over the fender. If my copper gasket off the other filter fits the handle I will stick on the new one after lunch.

Follow Ups:

• roll pin - Kaegi 13:27:41 11/23/2015
• Re: Still won't Start Must be Flooded?? - Willy-N 19:36:58 11/22/2015
  • Jumping plug wires won't fix it. - Chris Case 22:27:33 11/22/2015
    • Re: Pump has 10 Teeth on it not 8. - Willy-N 16:58:04 11/23/2015
      • 10 is still not 6. Jumping wires won't make 7:00.nm - Chris Case 17:23:14 11/23/2015
        • Re: 10 is still not 6. Jumping wires won't make 7:00.nm - Willy-N 20:41:05 11/23/2015
    • Re: Jumping plug wires won't fix it. - Willy-N 22:46:33 11/22/2015
      • Right way to pull a dist, counts on these oil pumps- - Chris Case 12:10:10 11/23/2015
      • Re: Pretty Bad when Arcives Answers You? - Willy-N 00:20:57 11/23/2015
        • Re: Pretty Bad when Arcives Answers You? - Doug Cartwright 00:36:12 11/23/2015
          • Re: Pretty Bad when Arcives Answers You? - Willy-N 00:39:05 11/23/2015
            • Re: Pretty Bad when Arcives Answers You? - Daryl in Oz 01:52:59 11/23/2015
              • Re: Pretty Bad when Arcives Answers You? - Willy-N 02:04:33 11/23/2015

Post a Followup