Posted by Chris Case [108.247.147.90] on Wednesday, November 18, 2015 at 11:49:28 :
In Reply to: almost fits posted by clueless [201.202.24.222] on Wednesday, November 18, 2015 at 10:35:59 :
That pic of ODSPARES.com conversion unit looks like a longer front nose, rather than Dennis's made from one piece of aluminum plate. So lengths may be different.
Dennis, from a read elsewhere, does your system use a slip yoke to fit the front shaft, so no threading of the input shaft? plus a bronze sleeve bearing and a seal? A little bit of slip is a good thing. Then, one rear crossmember with a drop loop, and a front crossmember above?
Hmmm, I wonder if there is an off the shelf rear yoke that would go direct to the U-joint? A bit more cost, but neater install? Longer rear drive shaft maybe?
Follow Ups: