Posted by clueless [186.15.45.20] on Friday, November 13, 2015 at 13:23:26 :
In Reply to: Re: 237 Engine Question, Help Needed. posted by clueless [201.202.24.222] on Friday, November 13, 2015 at 11:37:56 :
will try again and post
nothing in my block that resembles a mount for a flow thru
and 237 is a tad diff than my 230
237 drain from the filter to a lower fitting in the block just behind the starter and comes in to the filter from a higher fitting in the block just in front of the starter
where as the 230 drains from the filter into a low fitting jsut in front of the starter and comes in to the filter from a fitting further forward and higher by the oil filler spout--not sure if this helps
there also appears to be a hole in the block in the 237 right below the one that goes into the filter for possibley the lower one but something is broken off in it
filter outlet should be in the block lower than the inlet as far as i can tell so you can probably use any one of a no. of holes in the block--but i am no xpert yet!!
Follow Ups: