Posted by Willy-N [72.171.192.122] on Monday, November 02, 2015 at 14:54:00 :
Got the drivers side wiper motor in and it fits good. Had to cut a 3/8" deep 1 1/2" long section off the roof seam inside the cab. Just the curled up part not into the seam. Need the room to get it in the hole behind it. Then you don't need it cut out to fit once it is behind the seam. Putting the 2 screws in the lower holes in the cover is hard to do. I am using a Chevy Wiper Switch it fits in the hole on the cover plate on the drivers side. It also has the proper terminals for the motors with hi/lo speed and park. Just need to wire them in to locate the park positions on each motor to match. Nice part is they both match on the outside, same angle, same motors & wiper arms & blades. The covers go over them and only that little bit of the gear box sticks out below the valance. I am going to finish the inside of my one tool box since it is not raining out then do the wiring on the wiper motors. Need to get the windshield gasket in all the way being a bugger on me on the lower corners!
Follow Ups: