Re: Milling the Head

Posted by Dave Horvath [98.239.144.92] on Saturday, October 31, 2015 at 19:44:08 :

In Reply to: Milling the Head posted by Dave Horvath [98.239.144.92] on Saturday, October 31, 2015 at 19:39:04 :

Was about .006 low in the center. Now good as new.

Follow Ups:

• Re: Milling the Head - Kaegi 20:12:23 10/31/2015
• Re: Milling the Head - Dave Horvath 19:48:14 10/31/2015
  • I did .060" on my 230, - Tom in Indiana 20:25:23 10/31/2015
    • Re: I did .060" on my 230, - Dozerman51 21:04:02 10/31/2015

Post a Followup