ok--i will fall for the bait and see how bad

Posted by clueless [186.15.45.28] on Saturday, September 19, 2015 at 01:31:50 :

In Reply to: there is always some idjit who wants to change something posted by Bruce in BC [24.207.113.171] on Saturday, September 19, 2015 at 00:50:18 :

i get beat up or if i even get a reponse at all

i like the toyota rotor 12.33 dia. 1.25 thick and 3.27 tall 25 lbs and 5 holes for the front and like 2 piston caliper for clearance reasons but the toyota come with the above 4 piston-- i was looking for a 2 piston to fit this rotor but could not find one yet except willwood but they are expensive but might be an option

and i like the ford f450 rotors for the rear 12.9 dia 1.5 thick 4.88 tall and 34 lbs with 10 holes and appears several models of 2 piston calipers available to fit this rotor

both scenarios can use a spacer on the back of the the hub that drives on with the lug studs and threaded for the rotors

the 12.9 rotors might work on the front but i kinda like the lighter ones for the front and apparently eaiser to mount and clear the knuckle---lol

Follow Ups:

• if the four piston fits then use it - Bruce in BC 10:57:13 09/19/2015
  • Re: if the four piston fits then use it - ed 11:31:03 09/19/2015

Post a Followup