Re: Poly valve spring question

Posted by Kaegi [76.22.23.236] on Wednesday, August 26, 2015 at 21:27:07 :

In Reply to: Re: Poly valve spring question posted by Joe Cimoch [68.116.180.42] on Wednesday, August 26, 2015 at 19:48:25 :

I did see those numbers but wanted to see it from the factory parts manual. Cant trust the parts outfits for accuracy anymore. But that does seem correct. All springs look the same and are 2 inches (except the bad ones). This engine has probably turned over 4 times. I get block, crank and rods/pistons on Friday. .040 over, .010/.010 on crank. Going with slightly larger than stock cam. might run a 4 barrel. should spin the skinny 19.5s pretty good with 4.88s. ;/)

Follow Ups:

• Re: Poly valve spring question - Glen of Idaho 21:36:54 08/26/2015
  • Re: Poly valve spring question - Kaegi 01:07:54 08/27/2015
    • Re: Poly valve spring question - Glen of Idaho 22:54:07 08/27/2015
      • Re: Poly valve spring question - Kaegi 22:57:47 08/27/2015
        • Re: Poly valve spring question - Glen of Idaho 23:23:44 08/27/2015
          • Re: Poly valve spring question - Kaegi 02:07:06 08/28/2015
            • Re: Poly valve spring question - Glen of Idaho 10:32:03 08/28/2015
              • Re: Poly valve spring question - Kaegi 11:52:00 08/28/2015
                • New Poly piston pic - Kaegi 19:56:55 08/28/2015
                  • Re: New Poly piston pic - Glen of Idaho 20:38:57 08/28/2015
    • Re: Poly valve spring question - Glen of Idaho 10:58:56 08/27/2015

Post a Followup