1/2 Ton WC front spring arch

Posted by Don in NH [216.107.193.154] on Wednesday, August 19, 2015 at 12:43:51 :

Hi all,

I'm not sure how it is measured (offset from a line or the radius of a circle or ??), but does anyone know the specs on the front spring arch a 1/2t WC? From the center-line between the eyes to the top of my spring pack it is about 2", when on the bench. When on the truck with 250# of snow plow mount on the front they were running flat to slightly downward at the rear.

I want to add some leaves from my generous donor truck, but I'm wondering if the shape is correct. I might try to cold-arch them with my fly-press if I can find out what the target shape should be.

Thanks,

don

Follow Ups:

• Re: 3/4 pic from TM9-808 page 320 - don in nh 14:20:41 08/20/2015
• Re: 1/2 Ton WC front spring arch - Rick in MA 20:51:58 08/19/2015
  • Re: 3 1/4 using your measurement method. Ntxt - don in nh 20:14:39 08/20/2015
  • Re: 1/2 Ton WC front spring arch - Don in NH 09:42:01 08/20/2015
• Re: 1/2 Ton WC front spring arch - scott 56 20:14:18 08/19/2015
  • Re: 1/2 Ton WC front spring arch - Don in NH 10:24:15 08/20/2015
    • Re: 1/2 Ton WC front spring arch - scott 56 13:26:12 08/20/2015
  • Re: 1/2 Ton WC front spring arch - Mike O in CO 20:27:10 08/19/2015
    • Re: 1/2 Ton right side spring mount - don in nh 20:13:06 08/20/2015
      • Re: my parts truck has shorter ones I think. - don in nh 20:31:52 08/20/2015
    • Re: 1/2 Ton WC front spring arch - scott 56 13:30:30 08/20/2015
    • Re: 1/2 Ton WC front spring arch - Don in NH 10:00:43 08/20/2015
      • Re: 1/2 Ton WC front spring arch - Don in NH 14:57:12 08/20/2015

Post a Followup