Posted by Vaughn on Friday, August 24, 2001 at 11:49PM :
In Reply to: Bad timing marks on M-37s?? posted by George on Friday, August 24, 2001 at 9:18PM :
Two ways to time an engine: 1-by timing marks, 2-by octane. Check top dead center marks (block/harmonic balancer), note marks and correct for zero marks, time accordingly.
By octane, in 4th at 20mph, press gas pedal to floor and advance timing until you get initial pings. Timing is then set for octane being used.
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |