Posted by Kevin in Ohio [104.240.166.1] on Tuesday, July 07, 2015 at 00:31:37 :
In Reply to: Re: Painless Wiring on WDX posted by Jim in Litchfield Park [24.251.253.225] on Monday, July 06, 2015 at 22:46:53 :
That's the thing with the Painless harness as there is a lot of things you don't need. Heck, I didn't even have a radio!
Just don't use the extras. lay the whole thing out and short coil all the ones you don't think you'll need. Don't cut them till you're done and have everything covered. As I said, I did keep a few spares for what ifs.
Not sure what you mean on the switch having 7 points.
The six volt turn signal switch is nothing. You don't use the 6 volt one that came with the switch, use the one on the panel and wire accordingly. Depending on which Signal Stat switch you have you may have a 6 volt bulb to change in the switch. Other than that it doesn't care if it's 6 or 12 volt. It wires the same.
There were directions with the kit correct? There was with mine. Just do one circuit at a time while laying it out till all is covered.