Posted by Willy-N [72.171.192.59] on Wednesday, May 13, 2015 at 17:45:31 :
In Reply to: Rivet removal posted by Dan (NH) [173.9.49.14] on Wednesday, May 13, 2015 at 15:13:17 :
If I did this a lot I think I would use a portable hydraulic C-Press. I know shops use a shoulder pin that goes inside some to push out the rod bushings. A torch scares me when I cut on a frame, hard to fix mistakes later. Not good enough yet to trust my work on those parts.