Posted by Bruce in BC [24.207.104.104] on Tuesday, April 14, 2015 at 15:37:14 :
In Reply to: Forgot a photo posted by Sterling Luttrell [99.58.180.94] on Tuesday, April 14, 2015 at 15:32:05 :
You could press out the metal sleeve and then each half of the urethane will pop out each opposite way. Either make a pin pusher on a lathe or get a bolt that is the inside diaper of the sleeve and slide a piece of pipe over 1/2 the bolt. Then press away. Support the urethane bushing while doing this.