Posted by travis kingsbury on Wednesday, August 08, 2001 at 5:35AM :
In Reply to: Re: Attention 273-318LA RKI's - NEED HELP!!! posted by Brian in Oregon ntxt on Tuesday, August 07, 2001 at 10:58PM :
It sounds to me like you need a crank pulley off of a newer engine, they are offset about a half of a groove further out than the older ones. That should work with the large diameter deep pulley. I once spaced the lower pulley out with 3/8 nuts between the damper and pulley just so I could start and run a motor without over heating it. You dont need to invent a spacer for your fan, just get a non clutch fan with spacer off of something older.
Travis..
|
Follow Ups:
This board is powered by the Mr. Fong Device from Cyberarmy.com |