Posted by Willy-N [72.171.192.119] on Sunday, March 08, 2015 at 21:53:51 :
In Reply to: Re: Finished pulling Pistons today, 230 Crank posted by Willy-N [72.171.192.60] on Sunday, March 08, 2015 at 21:12:10 :
I put 1 wrist pins in two and the other end was flush. The pistons did come right up to the top almost but I was not looking to measure the stroke when I pulled them out. Did not know there was a 230 crank in it. Once it is back together I will measure it. The wrist pins were also the same size as the T137 not sure why the extra wear gap in my pistons? A lot of years(16 plus) with very few miles each year plowing snow? New .040 over 230 pistons & rings(gaped right) plus new rod bushings will help the compression go above 120 lbs. I will replace the .010 over rod bearings at the same time.
Follow Ups: