Re: Measured Bore and it is Good! I think?

Posted by Willy-N [72.171.192.61] on Thursday, March 05, 2015 at 23:33:56 :

In Reply to: Measured Bore and it is Good! I think? posted by Willy-N [72.171.192.122] on Thursday, March 05, 2015 at 23:17:06 :

I did my math again it comes out to a difference between the biggest and smallest diameter top or bottom is only 0.0016 between all the pistons. Now saying that, the taper per cylinder is#1-.0027, #2-.0023, #3-.0018, #4-.0011, #5-.0027 and #6-.0035 so were talking small amounts of wear. Am I wrong on this?

Follow Ups:

• Re: Measured Bore and it is Good! I think? - Sunny and warm coast Bruce 00:31:43 03/06/2015
  • Re: Measured Bore and it is Good! I think? - Willy-N 12:09:03 03/06/2015
• .007 max? So, good to go. - Chris Case 00:28:26 03/06/2015
  • Re: .007 max? So, good to go. - Willy-N 00:45:30 03/06/2015
    • It's your hobby, have at it. - Chris Case 09:35:30 03/06/2015
      • Re: It's your hobby, have at it. - Willy-N 12:05:11 03/06/2015
      • Re: It's your hobby, have at it. - Willy-N 11:47:28 03/06/2015
        • White smoke = water vapor, probaly cold, warming up muffler? - Chris Case 14:14:51 03/06/2015
          • Re: White smoke = water vapor, probaly cold, warming up muffler? - Willy-N 16:23:38 03/06/2015
        • White smoke is coolant leak. ntx - gmharris 14:09:09 03/06/2015
    • Re: .007 max? So, good to go. - scott 56 09:01:52 03/06/2015
      • Re: .007 max? So, good to go. - Willy-N 11:50:13 03/06/2015
  • Not only that - Sunny and warm coast Bruce 00:33:43 03/06/2015
    • Re: Not only that - Willy-N 00:46:22 03/06/2015

Post a Followup