Nice Day for Outside PW Stuff

Posted by Willy-N [72.171.192.117] on Sunday, February 08, 2015 at 21:33:04 :

Got to the mid 50s and sunny. Went out and pulled the 2 Front Fenders and 3-Floor Boards. Got the driver side done and painted. The center cover I am fixing it up. For the first time I welded a section of sheet metal into another and blended it in. Then I had to cut 1/2 of the 4 1/2" hole and flare it the same using a hammer & torch. Turning out a lot better than I figured but this was a big hole cut for the shifter.
Found out the tranny is a 2nd Series in the 6X6 and now I can see way more on the truck.

Follow Ups:

• Re:Before Part Picture - Willy-N 22:33:42 02/08/2015
  • Re:Before Part Picture - Willy-N 12:59:33 02/09/2015
  • Re:After Part Picture - Willy-N 01:21:43 02/09/2015
    • Re:After Part Picture - Keith In Washington 10:57:40 02/09/2015
    • Re:After Part Picture - Just plain wet coast Bruce 10:52:07 02/09/2015
      • Re:After Part Picture - Willy-N 12:53:57 02/09/2015
        • The only other bit of advice that might help - Just plain wet coast Bruce 16:16:43 02/09/2015
          • Re: The only other bit of advice that might help - Willy-N 21:39:10 02/09/2015
            • Re: The only other bit of advice that might help - Willy-N 21:50:45 02/09/2015

Post a Followup